Adjusting The Difference Between Images And Audio (Audio Delay Function); Turning Off The Volume Limitation - Panasonic Sound Slayer SC-HTB01 Owner's Manual

Adjusting the difference between
images and audio (Audio delay
function)
(Factory default: Auto)
This function delays the output of audio when you can
perceive a difference between the images and audio
when playing back a connected device. Adjust the
level while checking whether the images and audio
match.
• The delay time will not get shorter if you select a setting
value that is shorter than the time required to process
the audio signal. The time required for processing
signals depends on the audio format.
1 Press and hold [CLR DIALOG] on the remote
control for 4 or more seconds. (The LED
indicators indicate the current mode.)
2 Press [CLR DIALOG] while the current status is
being indicated (about 10 seconds).
• Switch to a status where you can select a setting
other than "Not Auto(Minimum to 300 msec)".
Setting
value
(msec)
Auto
Minimum
25 to 75
100 to 175
200 to 275
300
(Maximum)
Indicators
Operation
3 Press either [i SUBWOOFER] or
[SUBWOOFER j] while the current status is
being indicated.
The setting changes in the following order each time
you press [i SUBWOOFER]. (The setting changes in
the reverse order if you press [SUBWOOFER j].)
"Minimum" →"25 msec" → "50 msec" → "75 msec" →
... → "300 msec" (Maximum)
The display returns to the normal one about
10 seconds after the operation.
To return the audio delay to "Auto"
Press [CLR DIALOG] in step 2.
• The (Bluetooth
switches to "Auto".
• When set to "Auto", if a Panasonic TV (VIERA) that
supports VIERA Link (HDMI) Ver.3 or later is connected,
the audio is automatically delayed to bring it closer to
the images.
• This operation is not available when input is "
(Bluetooth )".
®

Turning off the volume limitation

(Factory default: Enabled)
This function limits the excessive output of volume.
When this function is used, if the volume exceeds 50
when this system is turned off, then the volume is set
to 50 when it is turned on again. You can set this
system not to use the function using the following
procedure.
1 Press and hold [VOL i] on this system and
[MUTE] on the remote control at the same time
for 4 or more seconds.
2 Confirm that all the LED indicators blink once.
• To enable the volume limiting function again, return the
settings of this system to the factory defaults. (
18
) indicator lights and the setting
®
20)