Table of Contents
Advertisement
In the case of an assembly with automatic
CHIPS control and several units, only one
of which is equipped with a control circuit
board, position the unit with the control
circuit board in the middle of the row.
Units of different widths can be positioned
in random order.
Make sure that the inspection and intake
sides of the units remain accessible for
maintenance.
w
Warning:
Make sure that all units can freely take in
and discharge air across their entire
width
2.3.3 Suspending the unit
NOTE: All hardware is field supplied.
Perform the following actions for each unit:
1. Lay the unit in a horizontal position.
2. Fit threaded rods
holes on the top of the unit.
3. Provide all threaded rods with lock nuts
and tighten them against the top of the unit.
n
Note:
The threaded rods must be secured,
otherwise the unit may fall down.
4. Fit lock nuts
5. Bring the unit into position using lifting
equipment.
6. Place the suspension rails
auxiliary structure, and fasten them with
nuts and lock washers
rods from the unit.
7. Allow the unit to hang freely.
20
(M12) in all screw
1
to each threaded rod.
3
on the
4
to the threaded
5
2
Advertisement
Table of Contents
