Assembling The Blower - Toro Power Plex 51134 Manual

Setup
Note:
The battery pack is not fully charged when you
purchase it. Before using the tool for the first time,
refer to Charging the Battery Pack (page
1
Mounting the Battery
Charger (Optional)
No Parts Required
Procedure
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the charger.
Mount it indoors (such as a garage or other dry place),
near a power outlet, and out of the reach of children.
Refer to Figure 1 for assistance in mounting the
charger.
Note:
Slide and twist the charger over the
appropriately positioned hardware to secure the
charger in place (hardware not included).
9).
Figure 1
2

Assembling the Blower

Parts needed for this procedure:
1 Blower tube
Procedure
1. Slide the blower tube onto the blower housing.
You may need to press down on the tab for the
blower tube to lock into place
1. Tab
2. Align the cavity on the battery pack with the
tongue in the handle housing, grasp the handle,
and push the battery pack into the handle until
the latch locks into place
1. Battery latch
g194202
7
(Figure 2).
Figure 2
(Figure 3).
Figure 3
g190102
g194149