Download Print this page

Qdos Zero-Screw Furniture Anti-Tip Kit Manual

Download this manual

Easy 3-Step Installation Guide

Before removing the adhesive protective liner, do a dry run and test each step

to make sure the installation will work. The SecureHold adhesive is meant to be

used once only and cannot be repositioned if done incorrectly.

Important:

Qdos wants to keep your children safe and for that we need you to do your part by

carefully reading and following the instructions below.

For installation videos and FAQs go to: QdosSafety.com

Parts List:

Adhesive

Furniture

Plate

2 Cam

Locks

Hinge

Zero-Screw Furniture

Anti-Tip Kit

2 Covers

for Cam

for Wall

Lock

Bracket

Strap

4 Secure

Hooks™

2 Wall

Bracket

4 - 1.5" (35

mm) Screws

Page 1 Important: Qdos wants to keep your children safe and for that we need you to do your part by carefully reading and following the instructions below. For installation videos and FAQs go to: QdosSafety.com...
Page 2 Step 1 - Positioning and attaching the Wall Brackets The Furniture Anti-Tip Kit should be placed within 2-15” (5-35 cm) of each end of the furniture. There are two options how to attach the Wall Brackets. (1A) The Ze- ro-Screw option into a hollow drywall using the Secure- Hooks™...
Page 3 1B - Screw into Stud Behind Drywall Locate the studs by using a stud finder. Carefully mark the center locations of the studs at the top of the furniture. Pull the furniture out from the wall and measure 18” (45 cm) down and mark the location for the Wall Brackets. Test one more time with studfinder to secure.
Page 4 Step 3 - Taking slack out of strap The final step is to move the furniture back closer to the wall and take the slack out. While pushing in the release lever on the Cam Lock, pull upwards on the strap to remove the slack.