To Operate Safely - Ugolini AC 5.2 Operator's Manual

with electrical codes in force in your area,
suitable to at least 10 Amp 250 Volt (220-
230 Volts 50-60 Hz areas) and 20 Amp 250 Volt
(100-115 Volts 50-60 Hz areas) applications.
Should you prefer to connect the unit directly to
the mains, connect the supply cord to a 2-pole
wall breaker, whose contact opening is at least 3
mm. Do not use extension cords.
ATTENTION
Failure to provide proper electrical ground
according to applicable electrical codes could
result in serious shock hazard.
10
Always leave the cooler on: the refrigeration
stops automatically when water reaches the
factory preset temperature. To reset temperature
please apply to a technician.

4 TO OPERATE SAFELY

1
Do not operate the dispenser without
reading this operator's manual.
2
Do not operate the dispenser unless it is
properly grounded.
3
Do not use extension cords to connect the
dispenser.
4
Do not operate the dispenser unless all
panels are restrained with screws.
5
Do not put objects or fingers in panels
louvers.
5 MAINTENANCE (TO BE CAR-
RIED OUT BY THE SERVICE
PERSONNEL ONLY)
Once a year clean all internal components,
primarily the condenser, using compressed
air.
To clean these internal parts, unplug the unit
or switch off the 2-pole wall breaker, then
remove the access panel.
7