Chamberlain LSIAC User Manual page 2

Assemble Intercom
Step 1
Install 4 AA Alkaline batteries (not provided). (Lithium
batteries recommended for colder environments.)
Step 2
Adhere rubber pads to bottom.
Repeat Steps 1 and 2 for any additional intercoms.
Programming Intercom
The intercom must be programmed to at least one
other intercom to become a network or it can be
programmed into an existing network.
Create New Network
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put the second
intercom into Learn Mode (refer to the following
table).
INTERCOM
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
Add to an Existing Network
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put any networked
intercom into Learn Mode (refer to table below).
INTERCOM
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
NOTE: Do not program new intercoms to each other
before adding them to the network or they will form a
separate network and the memory will need to be
cleared.
Press and release the Talk button to verify network is
complete.
2
LEARN MODE
Press the Learn
button until a
OR
beep is heard.
Press and hold
both buttons for
5 seconds.
LEARN MODE
Press the Learn
button until a
OR
beep is heard.
Press and hold
both buttons for
5 seconds.