Synca Kurodo E Operation Manual page 8

How to Use the Auto Mode Course RFID-operated
1 1 1
Touch the authenticated RFID to
symbol on the control till the course button
indicators start blinking.
2
Select a desired course and press the
button to enjoy a massage.
3
Massage course will automatically end
when the given time is up.
※ This section is only applicable when the chair is installed
with RFID-OP module.
How to Use the Auto Mode Course QR-operated
1 1 1
Open the authenticated gym app and QR
code or barcode from authenticated
membership ID.
2
Hold phone with QR code on screen or
barcode 1 inch away towards the scanner
to activate (the course button indicators
start blinking).
3
Select a desired course and press the
button to enjoy a massage.
4
Massage course will automatically end
when the given time is up.
※ This section is only applicable when the chair is installed
with QR-OP module.
How to Use the Auto Mode Course Coin-operated
1 1 1
Chair will power on and the course button
indicators start blinking after the required
token is inserted into token control box.
2
Select a desired course and press the
button to enjoy a massage.
3
Massage course will automatically end
when the given time is up.
※ This section is only applicable when the chair is installed
with token control box.
2.
1.
3.
2.
1.
2.
After Completing the Massage
Timer Function
1
The massage will complete
automatically in approximately 10
minutes after the start of operations.
• The knead balls will automatically move to the
stored position.
• The backrest and the legrest will move to their
stored positions.
2
To interrupting the massage
Press or to stop the massage. The
remaining time will be cancelled.
3
If you experience any problems during use:
Press or to stop the massage. The remaining time will be cancelled.
• All operations will be stopped and knead balls and the backrest, the legrest will move to
their stored positions.
• Get off the unit carefully to prevent the unit tipping over.
Disconnecting the power
1
Make sure the power switch is in the "O" (Off) position.
2
Remove the power plug from the power outlet.