Screw Glue tube Philips head screwdriver required for assembly (not included) The hardware quantities listed above are required for proper assembly. Some extra hardware may also have been included. Copyright 2018, by Walker Edison Furniture Co., LLC. All rights reserved.
Page 5
Attach cam bolt (B) to part (6,7,1) with screwdriver. Insert wooden dowel (A) into part (3,4,5,8).
Page 6
Attach part (5,3) to part (7,6), then insert and secure cam lock (C) to part (5,3) to lock it. Attach part (3,6,5,7) to part (8), then insert and secure cam lock(C) to part (8) to lock...
Page 7
Attach part (2) to part (3,4,5) using screw(G) with hex key (H). Note : Groove for the back panel should be aligned Slide back panel (10) into grooves as per diagram...
Page 8
Attach part (1) to part (3,4,5), then insert and secure cam lock (C) in part (3,4,5,8) to lock it. Attach plastic wedge (J) to part (13,14,9) using screw (F) with Hex key (H).
Page 9
Attach plastic wedge (J) to part (9) using screw (F) with Hex key (H). Attach plastic wedge (J) to part (9) using bolt (F) with Hex key (H).
Page 10
Attach part ( 9,14,13)to part (2) using plastic wedge( J)with hex key (H). Attach plastic wedge (S) to part (10) using screw (R) with screwdriver.
Page 11
Place sticker (D) over holes as per diagram. Insert shelf support pin (K) into part (3,4,5).
Page 12
Place shelf (11) on top of support pin. Attach pulley (N) using bolt (T), and door guide (M) using screw (L) to part (12) with screwdriver.
Page 13
Place door guide (M) on door into groove. Hang pulley (N) to part (8), then press down to hold the door...
Page 14
Use Screwdriver to secure Screw(L) to the L Shape Bracket (E) attach to the Part (12). Insert Nut (W) into the wall...
Page 15
Using screwdriver to secure screw (L) with the plastic strap (U) Secure product to wall with screw (V), through Plastic strap(U) by using screwdriver...