Aclam Guitars Windmiller User Manual & Safety Instructions page 22

Tighten the two thumb screws with your hands or
5
with a screwdriver.
22
USING OTHER PEDALBOARDS:
Hook and Loop: Take the included super strong Velcro
pad and stick it on the base plate.
Again, make sure the base is clean of dirt and dust.
Pre-drilled pedalboard: Fix it with a bolt and a nut you
could find at any hardware store or instead of passing the
zip tie over the pedal you can take advantage of the Smart
Track enclosure and put the zip ties over the holes.
®
DIY woodboard: You can screw the pedal directly with
wood bolts through the enclosure side holes.
No board: If you use the pedals standalone make sure you
place the included anti-sliding rubber pad on the baseplate.
®