Front Panel; Main Power Switch; Output Selector - Pro-Ject Audio Systems Box Design BT Box S2 Instructions For Use Manual

Front panel

Main power switch

The push button on the left hand side of the front panel turns the unit on or back into standby. The blue LED
above the power button indicates the status of the unit:
Slow blinking: Powered on, waiting for devices (no BT® device connected)
Fast blinking: Waiting for pairing confirmation - press power button to confirm pairing
Illuminated: BT device connected, ready to play

Output selector

Pressing the push button on the right side switches between the analogue output and digital output. LED above
selector is illuminated once digital output is selected.
BT connection
Pairing with Android devices
Open Settings and tap on BT. Turn on BT and tap on Scan. Searched devices will show up. Tap on BT Box
S2 and confirm presented pairing code on your Android device. Then confirm by pressing power button on
the left side of BT Box S2 as soon as the blue LED above power button is blinking. Confirm "Pairing" on your
Android device. When paired with BT Box S2, your Android device will show "Connected to media Audio".
Now you can play music from your Android device over BT to
BT Box S2.
Older devices may request a pairing code. Enter "0000" and confirm. No more confirmation on BT
Box S2 is then needed.
BT pairing with Apple devices
®
Tap on Settings, tap on BT, turn on BT. Your device will automatically start searching for available devices.
Tap on BT Box S2 and confirm by pressing power button on the left side of BT Box S2 as soon as the blue
LED above power button is blinking. Confirm "Pairing" on your Apple device.
A new connection is only possible if the Power LED is blinking slow (it indicates that no device is
connected). If a problem with BT connection occurs, it is necessary to reset memory and to delete all
paired devices. For reset turn off the unit > disconnect power supply > press & hold power button >
connect power supply > still hold power button for another 5 seconds > release power button. The
blue LED above the power button will blink for few seconds. When the LED stops blinking, memory is
erased and you can turn on the unit.
The LED above output selector switch blinks 3 times, once aptX™ is active.
© Pro-Ject Audio Systems · Pro-Ject BT Box S2 · Revision 2021.04.22
3