List Of Figures; List Of Tables - Jäger ADwin-Gold Hardware Manual

ADwin
Table of Figures
A-4 List of Figures
Figure 2-1: Concept of the ADwin-systems .................................................................................................... 7
Figure 2-2: Block diagram ADwin-Gold .......................................................................................................... 8
Figure 5-1: Schematic of ADwin-Gold .......................................................................................................... 12
Figure 5-2: Power supply connector .............................................................................................................. 13
Figure 5-3: Zero offset in the standard setting of bipolar 10 Volt ................................................................... 15
Figure 5-4: Jumper position on the analog printed circuit board ................................................................... 17
Figure 5-5: Pin assignment under configuration with CONF_DIO(12) .......................................................... 18
Figure 6-1: Position of the potentiometers for calibration .............................................................................. 24
Figure 7-1: Pin assignment of the DA add-on ............................................................................................... 28
Figure 7-2: Position of the potentiometers for calibration (DA add-on) ......................................................... 28
Figure 8-1: Pin assignment of the OPT add-on ............................................................................................. 29
Figure 8-2: Position of the jumpers for the input voltage range (OPT add-on) .............................................. 29
A-5 List of Tables
Table 5-1: Hardware addresses of the control and data registers for the ADC ............................................. 20
Table 5-2: Hardware addresses of the control and data registers for the DAC ............................................. 21
Table 5-3: Hardware addresses of the digital inputs/outputs ......................................................................... 22
Table 6-1: Test values for the adjustment of the DACs/ADCs ....................................................................... 25
Table 8-1: Technical data of the OPT add-on ................................................................................................ 31
Table 9-1: Pin assignment of the CO1 add-on .............................................................................................. 33
Table 9-2: Hardware addresses of the CO1 add-on ...................................................................................... 40
Table 9-3: Technical data of the CO1 add-on ................................................................................................ 40
Technical data - general overview ................................................................................................................. 44
Hardware addresses - general overview ....................................................................................................... 47
50
ADwin-Gold Hardware Manual, Version 2.3