Dell SE2219H Teardown Instructions page 2

DELL SE2219H, SE2419H
S7 Flip chassis, remove mylar.
Use Philips-head screwdriver
remove PCBAs screws.
M3 x 5 & M3 x 6 for ground screw.
Torque = 6.0 kgf +/-0.5 kgf
S8 Remove cables from IF & power board.
S9
Use Philips-head screwdriver
remove 11 screws from mid-frame
M3 x 4. Torque: 3.5 +/- 0.5Kgf.cm
S10
(
Φ5 mm) to
S11
( S12
Φ3 mm) to
Use Philips-head screwdriver
3 screws from mid frame (to disassemble front
trim).
T2 x3. Torque: 1.0 +/- 0.1Kgf.cm
Remove electrolyte capacitor >25mm height
mark) from printed circuit boards.
Cut the glue between bulk cap and PCBA with
knife – ensure cutting path within the glue, don't
touch bulk cap and PCBA.
Take out the capacitor pin solder with soldering
iron.
Lift the bulk capacitor away from power board.
(
Φ3 mm) to remove
(red
2