Celestron PowerSeeker 50 Quick Setup Manual page 2

Quick Set-up Guide [cont]
10
Orient finderscope so that it is facing toward
the front of the tube. Place finderscope over
screws as shown above.
13
Insert the diagonal into the focuser and tighten
the set screw to secure in place. Remove the
plastic cap on the diagonal.
16
To observe, look through the telescope as
shown above.
For detailed usage information please consult your owner's manual.
11
Replace knurled nuts to secure in place and
remove lens covers.
14
Place the 20mm eyepiece into the barrel of the
diagonal as shown above. Tighten the set
screw to secure in place.
17
For additional magnification, you can use the
included 3x barlow. Place the barlow in the
diagonal in place of the eypiece and tighten
set screw -- remove the cap from the barlow.
12
Loosen the set screw on the focuser and
remove the plastic cap.
15
Before you begin observing, remove the
optical tube cover.
18
Insert the chrome barrel of the 20mm eyepiece
into the barlow and tighten the set screw to
secure in place.