Eyepiece Projection - Celestron C11-SGT Instruction Manual

•
T-Max 400
•
Any 100 to 400 ISO color slide film
•
Fuji Super HG 400
•
Ektar 25 or 100
2. Center the Moon in the field of your telescope.
3. Focus the telescope by turning the focus knob until the image is sharp.
4. Set the shutter speed to the appropriate setting (see table below).
5. Trip the shutter using a cable release.
6. Advance the film and repeat the process.
Lunar Phase
Crescent
Quarter
Full
Above is a listing of recommended exposure times when photographing the Moon at the
The exposure times listed in table 7-1 should be used as a starting point. Always make exposures that are longer and
shorter than the recommended time. Also, take a few photos at each shutter speed. This will ensure that you will get a
good photo.
•
If using black and white film, try a yellow filter to reduce the light intensity and to increase contrast.
•
Keep accurate records of your exposures. This information is useful if you want to repeat your results or
if you want to submit some of your photos to various astronomy magazines for possible publication!
•
This technique is also used for photographing the Sun with the proper solar filter.

Eyepiece Projection

This form of celestial photography is designed for objects with small angular sizes, primarily the Moon and planets.
Planets, although physically quite large, appear small in angular size because of their great distances. Moderate to high
magnification is, therefore, required to make the image large enough to see any detail.
camera/telescope combination alone does not provide enough magnification to produce a usable image size on film. In
order to get the image large enough, you must attach your camera to the telescope with the eyepiece in place. To do so,
you need two additional accessories; a deluxe tele-extender (#93643), which attaches to the visual back, and a T-ring
for your particular camera make (i.e., Minolta, Nikon, Pentax, etc.).
Because of the high magnifications during eyepiece projection, the field of view is quite
small which makes it difficult to find and center objects. To make the job a little easier,
align the finder as accurately as possible. This allows you to get the object in the
telescope's field based on the finder's view alone.
Another problem introduced by the high magnification is vibration. Simply tripping the
shutter ⎯ even with a cable release ⎯ produces enough vibration to smear the image.
To get around this, use the camera's self-timer if the exposure time is less than one
second ⎯ a common occurrence when photographing the Moon. For exposures over
one second, use the "hat trick." This technique incorporates a hand-held black card
placed over the aperture of the telescope to act as a shutter. The card prevents light
ISO 50 ISO 100
1/2 1/4
1/15 1/30
1/30 1/60
Table 7-1
prime focus of your telescope.
43
ISO 200 ISO 400
1/8 1/15
1/60 1/125
1/125 1/250
Figure 7-1 - Accessories for
Projection Photography
Unfortunately, the