Celestron 60LCM Quick Setup Manual page 2

60 80 LCM Telescopes
&
10
Secure the tube to the base by
tightening the locking screw on the
top of the base.
13
Tighten silver screw to secure.
16
Plug Computerized Hand Control
into the "Hand Control" port on
the fork arm.
19
Place 8-AA batteries (user supplied)
inside the battery holder.
22
While observing, tube should be
positioned as shown above.
1 1
Insert the chrome barrel of the star
diagonal into the focuser and tighten
the two silver screws to secure in place.
14
Attach plastic hand control holder to
the tripod leg.
17
Press the tab on the front of the
battery compartment and remove
the cover.
20
Return the battery holder back inside
the base and replace the cover.
Before you can begin observing,you must setup your
hand control, align your finderscope and align your telescope.
Step by step instructions are included
in the following Hand Control Setup section.
Quick Set-up Guide
12
Select the low power (25 mm)
eyepiece and insert it as shown
above.
15
Slide Computerized Hand Control
into the hand control holder as
shown above.
18
Gently remove the battery holder
from inside the battery compartment.
21
Before you begin viewing, please
remember to remove tube lens cap.