Daily Use - Washing & Drying - AEG L9WEC163C User Manual

Washer dryer connected
Table of Contents

Advertisement

32
www.aeg.com
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
11.16 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Inicio/
Pausa button.
Press the On/Off button to activate
the appliance again.
12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
12.1 Complete wash&dry
programmes
Automatic Non-Stop
programme
The appliance is equipped with the
NonStop 3h/3kg programme, an
automatic wash&dry programme where it
is not necessary to set the Secar mode.
To run this programme:
1. After loading laundry and detergent,
press the On/Off button for some
seconds to activate the appliance.
2. Set the NonStop 3h/3kgprogramme
by means of the programme dial.
The indicator
3. Touch the Inicio/Pausa button to
start the programme.
Non-automatic wash&dry
programmes
In some washing programmes, you can
combine Lavar and Secar mode for
appears on the display
• After 5 minutes from the end of the
washing programme
Press the On/Off button to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
running a complete wash&dry
programme.
Proceed as follows:
1. Press the On/Off button for some
seconds to activate the appliance.
2. Turn the programme dial to the
desired washing programme. The
display shows the default
temperature and spin. If necessary,
change them according to your
laundry. The display also shows the
maximum recommended load for
washing phase.
3. Set the desired options, if there are
available.
4. Touch the Modo button once to
activate also the drying function. The
Lavar and Secar indicators come on.
The indicators
appear on the display. The display
also shows the maximum
recommended load for a washing
and drying programme (e.g. 6 kg for
cottons).
5. Open the door and load the laundry
one item at a time. On the display
the weight of the laundry is updated
by steps of kg 0.5 and the
programme duration is updated
accordingly.
6. Close the door.
7. Put the detergent and the additives
in the appropriate compartment.
and

Advertisement

Table of Contents
loading

Table of Contents