Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ZANKER WTF 968 A.8
Summary of Contents for ZANKER WTF 968 A.8
- Page 1 User manual Washing Ma- chine WTF 968 A.8...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 15 Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Daily Use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 16 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5... -
Page 3: Safety Instructions
• Obey the maximum load volume of 8 kg (refer to the “Programme chart” chapter). • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. •... - Page 4 • Do not change the specification of this appliance. • If you have washed your laundry with a stain remov- er start an extra rinse cycle before you start the ap- • Do not put flammable products or items that are wet pliance.
-
Page 5: Product Description
Product description Detergent dispenser drawer Control panel Door opening handle Rating plate Drain pump Adjustable feet Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak deter- gent is added at the beginning of the wash programme. -
Page 6: Special Accessories For Installation
To activate this device, To disable this device rotate the button (without and restore the possibility pressing it) inside the of closing the door, rotate door clockwise until the the button anti-clockwise groove is horizontal. If until the groove is verti- necessary use a coin. - Page 7 AUTOMATISCHE TROCKNEN button START/PAUSE button ZEITWAHL button ZEITVORWAHL button VORWÄSCHE button TÜR VERRIEGELT pilot light EXTRA SPÜLEN button Display 1-8 Programme selector dial, spin speed button, Available options: drying level and time, and available options VORWÄSCHE Programme Selector Dial By selecting this option the machine performs a pre- It allows you to switch the appliance on/off and/or to se- wash cycle before the main wash phase.
- Page 8 10 Display 10.1 10.2 The display shows the following information: 10.1 Child safety lock This device permits you to leave the appliance unattended during it's functioning. 10.2 • Duration of the selected programme After selecting a programme, the duration is displayed in hours and minutes (for example ).
-
Page 9: Washing Programmes
Washing Programmes Programme - Maximum and Minimum Temperature - Cycle Detergent Description - Maximum Spin Speed - Maximum Fabrics Options Compartment Load - Type of Laundry KOCHWÄSCHE/BUNTWÄSCHE SCHLEUDERN 95°- 30° SPÜLSTOPP Main wash - Rinses VORWÄSCHE Maximum spin speed at 1600 rpm EXTRA SPÜLEN Max. - Page 10 Programme - Maximum and Minimum Temperature - Cycle Detergent Description - Maximum Spin Speed - Maximum Fabrics Options Compartment Load - Type of Laundry FEINWÄSCHE SPÜLSTOPP 40°- 30° VORWÄSCHE Main wash - Rinses EXTRA SPÜLEN Maximum spin speed at 700 rpm ZEITVORWAHL Max.
-
Page 11: Automatic Drying Programmes
Programme - Maximum and Minimum Temperature - Cycle Detergent Description - Maximum Spin Speed - Maximum Fabrics Options Compartment Load - Type of Laundry EXPRESS 60°/45 MIN. SCHLEUDERN 40° SPÜLSTOPP Main wash - Rinses ZEITVORWAHL Maximum spin speed at 1200 rpm Washes 3 kg of cottons at 60°... -
Page 12: Consumption Values
Suggested Degree of Drying Type of Fabric Drying Load Spin Speed drying time in Minutes Cotton and linen 5 kg 120-150 Suitable for items to put away (bathrobes, bath tow- 4 kg 1600 110-120 without ironing els, etc) 2 kg 60-70 Suitable for items to put away Synthetics and... -
Page 13: Helpful Hints And Tips
Washing Pro- Beladung Energieverbrauch Wasserverbrauch Programmdauer gramme (KWh) (in Litern) (Stunden, Minuten) Waschen Baumwolle — Ener- 8 kg giesparen 60° 5.44 Trocknen (2 Zyklen) Zeittrocken 5 kg + 3 kg 1) Prüfprogramm nach EN 60456. 2) « E-SPAR » bei 60 °C mit einer Beladung von 8 kg ist in Übereinstimmung mit EEC 92/75 das Referenzprogramm für die im Energielabel eingetragenen Werte Programmeinstellung für Prüfungen nach bzw. - Page 14 The choice of detergent will depend on the type of fab- Quantity of detergent to be used ric (delicates, woollens, cottons, etc.), the colour, wash- The type and quantity of detergent will depend on the ing temperature and degree of soiling. type of fabric, load size, degree of soiling and hardness All commonly available washing machine detergents of the water used.
-
Page 15: First Use
• The average drying time for a timed drying are indica- = May be tumble dried ted in the «Drying programmes» chapter. The experi- • = Drying at high temperature ence will help you to dry your laundry in a more suitable •... -
Page 16: Daily Use
Daily Use Load the laundry Turn the selector dial to position to reset the pro- gramme/to switch the machine OFF. Open the door by careful- At the end of the programme the selector dial must ly pulling the door handle be turned to position , to switch the machine outwards. - Page 17 Select the Delay Start by pressing button 8 Interrupting a programme Before you start the programme, if you wish to delay Press the button 7 to interrupt a programme which is the start, press this button to select the desired delay. running, the corresponding pilot light starts blinking.
-
Page 18: Use - Drying
Stand by : once the programme has finished after a any button the appliance will come out of the energy few minutes the energy saving system will be enabled. saving status. The brightness of the display is reduced. By pressing Use - Drying Drying only Press button 7 to start the programme. - Page 19 Add detergent and fabric softener. Load the laundry and add detergent and fabric Switch the machine on by turning the selector dial softener. to the set washing programme/fabric. Switch the machine on by turning the selector dial Select the required options by pressing the rele- to the set washing programme/fabric.
-
Page 20: Care And Cleaning
Care and cleaning Warning! You must DISCONNECT the appliance Replace the drawer and run the rinse programme from the electricity supply, before you can carry without any clothes in the drum. out any cleaning or maintenance work. Cleaning the pump Descaling The pump should be inspected regularly and particular- The water we use normally contains lime. - Page 21 When the container is full of water, put the drainage Clean the filter under the water tap and put it back in duct back again and empty the container. Do steps 3 the pump into the special guides. and 4 again and again until no more water flows out Make sure that you tighten correctly the filter to pre- from the drain pump.
-
Page 22: What To Do If
disconnect the mains plug from the mains socket. • Turn off the water tap. close the water tap • Unscrew the hose unscrew the water inlet hose from the tap; from the tap. put the two ends of the inlet hose in a container •... - Page 23 • E10 : problem with the water supply. • EC1: the inlet valve is blocked. Once the problem has been eliminated, press the but- • E20 : problem with the water draining. ton 7 to restart the programme. If after all checks, the •...
- Page 24 Problem Possible cause/Solution Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose;...
- Page 25 Problem Possible cause/Solution The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laun- dry is still not evenly distributed in the drum, the machine will not spin.
-
Page 26: Technical Data
If you are unable to identify or solve the problem, con- tact our service centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: the Service Centre will require this infor- mation. Mod..Prod. - Page 27 If necessary, check the setting with a spirit level. Unscrew the three bolts Slide out the relevant Water inlet with the supplied span- plastic spacers. ner. Caution! • This appliance must be connected to a cold water supply • Before connecting up the appliance to new pi- pework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have...
- Page 28 The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larg- • After positioning the inlet hose, be sure to tighten er than the outside diameter of the drain hose. the ring nuts again to prevent leaks.
-
Page 29: Electrical Connection
Electrical connection Information on the electrical connection is given on the through failure to comply with the above safety rating plate on the inner edge of the appliance door. precaution. Check that your domestic electrical installation can take Caution! The power supply cable must be the maximum load required, also taking into account easily accessible after installing the machine. - Page 32 www.electrolux.com/shop 132940803-A-042013...