Standard Cycle - LG T4432S0Z User Manual

Standard Cycle

1
2
3
4
5
6
14
Press Power button.
● An indicator light will flash on Standard cycle.
Add laundry, close the lid, and press Start/Pause button.
● "Cold wash", rinse "2"times, and spin "medium" is automatically selected. If you want to
change, press Pause button and press each button to change.
The water level displays and water is supplied after the washer rotates the tub without
water in one direction to detect the water level. And then the washer repeats it one
time during water supply, and LED light flashes as water level is reset.
● The water level LED light flashes correspondingly when Start/Pause button is pressed after
water level is selected. It is a normal operation.
● You can change the settings after the washer detects washing load.
● When the washing load is being detected, make sure to close the lid for your safety.
(If the lid is open, the washer won't start as "lid open ("DE")" displays.)
Press Start/Pause button.
Add detergent following the amount shown next to water level display, and
close the lid.
Press Start/Pause button.
Water will be supplied, and the wash will begin after the water supply.
Power will be off automatically about 10 seconds after buzzer goes
off.
Check it again!!!
Check if water supply hose is properly connected to
1
ater and hot water.
2
Check if faucet is on.
3
Check if plug is on.
4
Check if drain hose is placed on the floor.
● Even when the water level is manually selected after
laundry added, the washer detects the washing load for
more thorough wash. So, rotating movement in one
direction before water supply is a normal operation.