1
4
2
5
Knöpfe die nicht in den Halter passen
Addieren Sie die Höhe des Knopfes und den Durchmesser des Knopfes,
und stellen Sie den so erhaltenen Wert auf der Skala des Knopflochfußes
ein. Der Abstand zwischen zwei Linien auf der Skala beträgt 0,5 cm.
Beispiel:
Bei einem Knopf mit dem Durchmesser 1,5 cm und einer Höhe von 1 cm
sollte die Skala auf 2,5 cm eingestellt werden.
1 Höhe [1 cm]
2 Durchmesser [1,5 cm]
3 Knopfhalterplatte
4 Skala
5 Durchmesser + Höhe [2,5 cm]
6 0,5 cm
57
3
6
Odd-shaped buttons that do not
fit into the button holder plate
Add the button diameter to its thickness, then set the buttonhole
presser foot scale to this measurement. The distance in the scale
between two lines of the same length is 0.5 cm (3/16").
Example:
For a button with a diameter of 1.5 cm (9/16") and a thickness of
1 cm (3/8"), the scale should be set at 2.5 cm (1").
1 Thickness [1 cm (3/8")]
2 Diameter [1.5 cm (9/16")]
3 Button holder plate
4 Scale
5 Diameter + thickness [2.5 cm (1")]
6 0.5 cm (3/16")
1
2
3
4
5
6