Table of Contents
Advertisement
Pan Forming
Pans of various sizes can be formed
with a maximum lip (side) of 1".
To form a pan:
Figure 13
1.
Pre-measure and cut the material
before bending. Notch the corners
according to the desired lip height.
Figure 14
2.
Insert the material between the Upper
Braking Die and the Apron. Bend the material
until a 90º angle has been formed.
Figure 15
3.
Rotate the material 90º counterclockwise.
Allow the completed side to extend just
beyond the Die. Bend the second side.
Item 5907
For technical questions, please call 1-888-866-5797.
Figure 16
4.
Repeat Step 3 for the third side.
5. Rotate to the final side, and insert the
workpiece between the dies. The formed
sides will be on the outside of the Die.
Figure 17
6.
Before bending, tap one corner
nearer to the middle of the machine.
This will allow the material to clear the
Upper Braking Die when raised.
7. Bend the fourth side.
8. Using a block or piece of wood, tap the
corner of material back into place.
Pressing
1. Slide the Press Plate Bracket (8) of the
Press Plate Assembly into the receiver
holes of the Apron. Note that the
Press Plate (10) should be facing down.
2. Place the workpiece so that it is
centered under the Press Plate.
3. Rotate the Handle (18) to press the workpiece.
Page 9
Advertisement
Table of Contents
