Table of Contents
Advertisement
Handle Removal & Adjustment
Adjust or move the Handle (18) by removing one of the Handle Knobs (26) and loosening
the Bolt (42) that holds the Handle in place. Slide the Handle out of its socket, move to the
opposite side of the tool if desired, and tighten it in the most convenient position.
Braking Die Installation & Adjustment
Upper Braking
Die (12-01
to 12-06)
Wood (not included)
Hex Head Bolt (52)
Figure 3
1.
The Upper Braking Dies (12-01 to 12-06)
can be used for varying sizes of box and
pan forming. When forming a smaller box
or pan, choose the desired size Upper
Die, center it and remove the others.
Item 5907
Moveable
Cutter
Plate
For technical questions, please call 1-888-866-5797.
2. The Shear Brake Roll can be used to
bend sheet metal up to 20 gauge.
3. The space between the Upper Die
and the Apron (11) is adjustable.
4. To adjust the spacing:
a. Place a flat straight piece of wood
(not included) between the Upper Braking
Die and the Apron and raise the Apron so
that the material just touches the Upper Die.
b. Loosen the Hex Screws (52) holding the
Upper Die in place. Do not remove them.
c. Remove any unneeded Upper Dies.
d. Raise and lower the Apron and
use the block of wood to adjust the
alignment of the Upper Dies.
e. Tighten the Upper Die Hex Screws.
Page 5
Advertisement
Table of Contents
