Kenwood DMX9720XDS Quick Start Manual page 22

HDMI input
7
Use HDMI cable KCA-HD100 (optional
accessory).
When you connect the cable to HDMI terminal,
remove the fixture. After connecting the cable,
put the fixture again.
Digital Radio antenna CX-DAB1 (Optional
8
accessory)
!
Use of a CX-DAB1(optional accessory) as a
Digital Radio antenna is recommended.
When using a commercially available Digital
Radio antenna, the diameter of the SMB
connector must be Φ6.5 mm or less.
Φ 6.5 mm (maximum)
Dashboard camera interface
9
Connect a Dashboard Camera DRV-N520
(optional accessory). (P.23)
AV Audio input (ø3.5 mini jack)
10
11
Accessory 6: GPS Antenna
Use the supplied GPS antenna. Using the GPS
antenna other than the supplied one may
cause a drop in positioning accuracy.
3rd view camera input (Yellow). See To set up
12
the camera assignment settings (P.23).
Rear view camera input (Yellow) *
13
14 Front view camera/Dashboard camera
See To set up the camera
input (Yellow).*
2
assignment settings (P.23).
Video output (Yellow)
15
16 Video input (Yellow)
*1 Connect an HD camera to Rear view camera
input terminal to use HD video.
*2 Connect an HD camera to Front view camera/
Dashboard camera input terminal to use HD
video.
Fixture
HDMI connector
1
Autogoods "130"
Connection/Installation
Ñ
Securing the USB extension cable
Secure the USB extension cable with insulating
tape or the like so that its connectors are not
disconnected.
Ñ
Connecting a USB device
Accessory 2 (1 m)
USB terminal
[1] USB maximum power supply current :
DC 5 V = 1.5 A
Sold separately
[2]
See Securing the USB extension cable
[3]
(P.21).
[3]
USB device
[2]
[1]
21
English