Cecilware Supercut-NB Operating And Maintenance Manual page 6

1.2 - DESCRIPTION OF THE MACHINE
PESTLE
PRESS
BASEMENT
COVE FASTENING
Fig. n°1 - General view of the Vegetable cutter mod. "TM"
DESCRPTION
The TM Vegetable cutter was specifically designed to cut vegetables, fruit
and mozzarella cheese guaranteeing:
- maximum safety when being used, cleaned and under maintenance;
- maximum hygiene, attained thanks to a scrupulous selection of
material that comes into contact with the food, and to the elimination of
sharp corners on the parts of the vegetable cutter that come into
contact with the product, this achieving easy and complete cleaning
and facilitating dismantlement;
- the robustness and stability of all the components;
maximum silence thanks to its belt transmission;
-
- great manageability.
PRESS HANDLE
HOPPER
STRUCTURE
HINGED CLASP
ELECTRICAL LEAD
ON OFF PUSH BUTTON
FEET
1.2.1 - GENERAL
6
4.4 - CHECKING THE FUNCTIONING ORDER
Test the functioning order using the following procedures:
a) Push the on button "l" and then the off button "O" and check that the
buttons start and stop the machine respectively
b) Check that the motor stops and subsequently starts when lifting and
lowering the press lever.
c) Check the machine stops when the cover is removed and that it
restarts pushing the START "l" button only once the cover has been
replaced.
d) Check as per point "c" removing and repositioning the tray or slide.
Fig. n°22 - ON/OFF switch
CHAP.5 - USE OF THE MACHINE
5.1 - DISC ASSEMBLY
A Select the desired disc choosing from DF 1-2-3-4-5-8-10-14, DTV, DT
2-3-4-7-9, or DQ 4-6-8-10; after having removed the steel or aluminium
cover, position it on the disc holding shaft. Let it rotate normally until it
is completely hooked. Replace the cover clamping it shut with the
hinged clasps of the steel cover or the fastening handle of the
aluminium lid.
B (FOR CUTTING CUBES)
Select the desired coupled discs from PS8-DF8, PS10-DF10, PS20-
DF14. First insert the PS disc, with the hollow side facing to the right
when on is facing the machine. Then assemble the DF disc with the
same procedure described in point "A"
NB: THE EXPULSION PALETTE MUST NOT BE ASSEMBLED
TOGETHER WITH THE COUPLED DISCS PS-DF
C Should the machine be supplied with the expulsion palette
advisable to use it together with the DF 1-2-3-5, DTV, DT 2-3-7-9, DQ4
discs. The palette must be assembled onto the disc holding pivot prior
to any other disc (
as per Fig. n°23)
procedure described in point "A".
(Fig. n°22).
ATTENTION!
(see Fig. n°24).
(Fig. n°9),
. Then assemble the disc with the same
19
it is