Important Information - DURAVIT Sundeck 700065 Mounting Instructions

Important information

About the mounting instructions
These mounting instructions come as part of the Duravit
bathtub and should be read carefully prior to installation.
Explanation of the key words and symbols
NOTE! For avoiding property damage
Link to installation information in this section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and tightness
Target group and qualification
The bathtub must only be installed by trained plumbing
engineers.
NOTE!
Local installation regulations and any country-specific
standards must be observed at all times.
Installation information
Please read pre-installation datasheets prior to the
installation. These are available to download on the
Internet at www.duravit.com.
6
Checking Bowden cable (Diagram 6)
> In the case of bathtubs with a pre-installed
Bowden cable, check the function and readjust it
if necessary.
8
Providing for an opening for a supply and drain line
and for maintenance (Diagram 8)
Area: drain and overflow fittings
Dimensions of the inspection hatch
for drain fittings: min. 20 x 20 cm
9
NOTE! Working with Polyurethane foam (Diagram 9)
> Read and follow the handling instructions before
working with Polyurethane foam.
16
Remedial action with tolerances (Diagram 16)
> With tolerances under the supporting surface, fill
the area below the edges with foam.
24
Closing inspection hatch (Diagram 24)
> Closing inspection hatch after tiling
Sealed to avoid spray water
Only to be opened with a tool
BA_M_Sundeck_Einbau_Fliesen/12.10.2
5