Battery - BMW F 800 GS Rider's Manual

Synchronising remote
control
Press and hold down button 1
and button 2.
LED flashes for ten seconds.
As soon as the LED goes out,
release button 1 and button 2.
LED lights up.
Press button 1 or button 2.
LED goes out.
Remote control has been syn-
chronised.

Battery

with alarm system (DWA)
When does the battery
have to be changed?
The batteries in the remote con-
trol must be renewed after ap-
proximately 2-3 years. You can
tell that the battery is weak if the
LED does not light up or lights
up only briefly when a button is
pressed.
Changing battery
ATTENTION
Batteries unsuitable or not
inserted in compliance with
correct procedure
Component damage
Use only the specified type of
battery (see "Technical Data").
When inserting the battery,
always make sure polarity is
correct.
OE
Remove screw 1 and remove
bottom part of housing 2.
Slide old battery 3 forward
from under retainer 4.
Insert a new battery. In this
process, make sure the positive
terminal of the battery is facing
upwards.
Position the lower housing sec-
tion on the lug 5 at the front
edge and close it. In this pro-
cess, observe the two guide
pins 6.
Install the screw.
The LED on the remote con-
trol lights up, indicating that the
5
65
z