Brake Adjustment; Seat Height Adjustment - Probasics RLS6BL Manual

the brake is applied or when the brake lock/parking brake
is engaged. If wheels turn while the brake is applied and/
or when the brake lock is engaged,
to use the rollator. Return to your dealer/distributor for
adjustment, repair, or replacement.

BRAKE ADJUSTMENT

1. Hold the top nut firmly in place.
2. To loosen the brake adjustment, turn the bottom nut
(closest to the bar securing the brake to the rollator)
counterclockwise. The nut will move away from the frame.
3. To tighten the brake adjustment, turn the nut clockwise.
The nut will move toward the frame.
4. Refer to below visual guide for further assistance.
INSTRUCTIONS TO ADJUST THE
HOLD FIRMLY IN PLACE.
DO NOT TURN
TO TIGHTEN THE HAND
BRAKE ADJUSTMENT,
TURN THE NUT CLOCKWISE
TO LOOSEN THE HAND
BRAKE ADJUSTMENT,
TURN THE NUT
COUNTER CLOCKWISE
POUCH INSTALLATION
G

SEAT HEIGHT ADJUSTMENT

* Applies only to RLAA8BK, RLAA8BG, RLAA8BL, RLAA8PK
1. Remove the adjustment knob from the rollator leg.
2. Depress the push pin button and slide leg to desired height.
6
HAND BRAKE SYSTEM
1. With rollator in unfolded position, lift
seat up to rest against the backrest.
2. Unsnap all buttons on nylon pouch.
3. Hang the pouch between the front
and back frame tubes, looping each
of the snap tabs over the bars, then
secure with snap buttons. Ensure
ALL
frame.
DO NOT
DO NOT
snap buttons are attached to the
*
continue
turn the top nut.