Honeywell HEIPTZ-2736-WI Quick Start Manual page 6

Ex
 If the PTZ Camera
set up the PTZ Camera
software) and enter system settings interface for time settings.
 Do not drop the PTZ Camera or subject it to physical shock, and do not expose it to
high electromagnetism radiation. Avoid the equipment installation on vibrations
surface or places subject to shock (ignorance can cause equipment damage).
 Do not place the PTZ Camera in extremely hot, cold, dusty or damp locations,
otherwise fire or electrical shock will occur. Refer to the product specification for the
operating temperature.
 Exposing the device directly to sun light, low ventilation or heat source such as heater
or radiator is forbidden (ignorance can cause fire danger).
 Use the provided glove when you open up the PTZ Camera cover. Avoid direct contact
with the PTZ Camera cover, because the acidic sweat of the fingers may erode the
surface coating of the cover.
 Use a soft and dry cloth when you clean inside and outside surfaces of the PTZ
Camera cover. Do not use alkaline detergents.
 Keep all wrappers after unpacking them for future use. In case of any failure occurred,
you need to return the PTZ Camera to the factory with the original wrapper.
Transportation without the original wrapper may result in damage on the PTZ Camera
and lead to additional costs.
Explosion-proof PTZ Camera·Quick Start Guide
fails to synchronize local time with that of the network, you need to
time manually. Visit the PTZ Camera
v
(via web browser or client