Advertisement
flickers. Stop turning for a few seconds, the setting will stop
flickering and the power will return to the initial status.
3. Over current protection: Press the RECALL key and the
storage direction will flicker. At this time, press OUTPUT and it
will stop flickering, then the power is in the mode of over
current protection; that is, the over current protection starts
then the current is up to the set value; Switch off the output
voltage and the over current protection light [OCP] is on.
Eliminating the mode of the over current protection: press the
RECALL key and the storage direction will flicker. At this time,
press OUTPUT and it will stop flickering, then the power
supplies will exit from the over current protection mode.
CONTROL MODE WITH BUILT-IN MEMORY
Storage Selection: Press the RECALL key and the storage
direction light will flicker, which indicates the current storage
data. Then press the ↓ key and the next parameters of voltage
and current can be selected; press ↑ and the previous
parameters can be selected. In any storage direction, the
relevant storage units can be stored then the parameters of
voltage and current are set
.
www.tmatlantic.com
7
Advertisement
