Related Manuals for Aktakom APS-7306L
Summary of Contents for Aktakom APS-7306L
- Page 1 User’s Manual PROGRAMMABLE DC POWER SUPPLY APS-7306L Thank you for choosing AKTAKOM Power Supply. www.tmatlantic.com...
-
Page 2: Brief Product Introduction
Power Supply APS-7306L in addition to stand-alone control (control and monitoring from the front panel) can be operated remotely by computer via USB 1.1 interface and LAN, or by a mobile device (IPad, IPhone, any Android-based mobile devices) via Ethernet. -
Page 3: Technical Parameters
Model APS-7306L Output voltage 0-30V Output current 0-5A Output power 150W TECHNICAL PARAMETERS These parameters are tested under 25±5°C and after 2s power Power effect: CV≤0.01%+3mV (AC±5%) Load effect: CV≤0.01%+2mV Ripple and noise: ≤2.0mVrms Output accuracy: 0.5%+20mV 0.5%+10mA Read-back accuracy: V:... - Page 4 DIAGRAMS OF PANELS Front Panel 1. Power: on/off button 2. Off/On: output on/off 3. MEN: memory save 4. M1-M3: memory recall 5. Voltage/Current: select between voltage or current 6. OCP: over current protection 7. CC indicator: constant current mode 8. CV indicator: constant voltage mode 9.
- Page 5 Rear Panel 13. Cooling Fan 14. Power cable connection plug 15. LAN port 16. USB port Fig. 2 www.tmatlantic.com...
-
Page 6: Manual Mode
The Power Supply can operate in several control modes: MANUAL MODE. CONTROL MODE WITH BUILT-IN MEMORY. REMOTE CONTROL MODE OF APS-730XL BY COMPUTER VIA USB INTERFACE. REMOTE CONTROL MODE OF APS-730XL BY COMPUTER VIA LAN INTERFACE. MANUAL MODE 1. Output Voltage Adjustment: Press the V SET key, the value of voltage setting will be displayed on the voltage display;... - Page 7 flickers. Stop turning for a few seconds, the setting will stop flickering and the power will return to the initial status. 3. Over current protection: Press the RECALL key and the storage direction will flicker. At this time, press OUTPUT and it will stop flickering, then the power is in the mode of over current protection;...
-
Page 8: Product Registration
PRODUCT REGISTRATION Please register on http://www.tmatlantic.com before the software installation and the device configuration for remote control mode operation Fig. 3 Fig. 4 And then download the program installer following the recommendations on the web site www.tmatlantic.com www.tmatlantic.com... - Page 9 ADJUSTMENT OF REMOTE CONTROL MODE OF APS-730XL BY COMPUTER VIA USB INTERFACE Connect the power supply to the power outlet using the power cable. Fig. 5 Switch on the power. Fig. 6 Connect the USB cable to the relevant inputs of the power supply and the PC.
- Page 10 Install AKTAKOM Power Manager 21 Light software to your PC. You can download the software from www.tmatlantic.com. If necessary the software can be recorded to the CD and shipped to the customer for an additional cost. To download the AKTAKOM Power Manager 21 Light software, go to www.tmatlantic.com, log...
- Page 11 Pic 2 Select the necessary interface type (USB or LAN), enter the settings for the network connection (IP, port, login) and press OK key to connect to the power supply. You will see the connection state in the main program window, "Connection state"...
- Page 12 After the device connection its current state will be displayed in Measurements block. Constant voltage and current mode is controlled by the elements of Control block. To switch on/off the output use Exit key. Visit www.tmatlantic.com for more information. www.tmatlantic.com...