Outback ProHarvest 208V Quick Start Manual

Buttons and Indicators
Button State Meaning
Initial state.
Once pressed, a dark blue color indicates the Gateway is in the process of discovering inverters. It will return
to the initial state with an empty serial number list if no inverters are found.
A dark red color indicates an error was found. Examples: "signal strength is too low"; "too much background
noise on circuit". The red color only clears when the user re-tries and the fault condition no longer applies.
Once discovery has successfully occurred, this button returns to the initial state.
Button Push Result

1 press Make inverter beep; i.e. "Are you alive?"
2 presses 
"Off & Locked". Unit is disabled.
Unit will not begin the 5-minute self-start.

3 presses 
Start generating immediately

If locked, unlock and generate immediately
If system is faulted, unit will unlock but

will not generate

Long press "Alternate functions" mode:
(> 2 secs) Ready to accept further button pushes.
This times out after 10 seconds.
1 press 
Clear latched faults; for example, after
(after long press) residual-current device (RCD) test or
arc-fault test has initiated a fault condition.
3 presses

(after long press) RCD-test activation. Successful activation
of RCD test should cause a fault condition
(rapid red flashing) until cleared.
4 presses

(after long press) Arc-fault test activation. Successful activation
of arc-fault detection should cause a fault
condition (rapid red flashing) until cleared.
900-0202-01-00 REV B
©2016 OutBack Power Technologies. All Rights Reserved.
Button and
LED Indicator
Indicator State Meaning

Solid Powered up
 Not generating
 No faults

Left-right flash Power-on self-test
Will take <1 minute


Green chaser Powered up

Generating, no faults
Rapid flash  Faulted; for example,
arc fault detected

Mostly on "Off and Locked";
unit is disabled
Mostly off 
Sleeping
 Not generating
Quick Start Guide
ProHarvest 208V
This guide provides instructions for installation and setup of the product. It assumes knowledge of features, functions, and general operation.
This guide is a supplement for the purpose of expediting installation. For complete information, see the ProHarvest Installation and Safety Manual.
These instructions are for use by qualified personnel who meet all local and governmental code requirements for licensing and training
for the installation of 3-phase electrical power systems with AC and DC voltage up to 1000 volts.
CAUTION: EQUIPMENT DAMAGE
!
This system is to be connected to 208 Vac 3-phase wye input ONLY (three phases, neutral, ground).

This product has no user-serviceable parts. Tampering with the product will void the warranty.

Applying incorrect polarity to DC string inputs will result in damage. This will void the warranty.

The Communications Gateway is for indoor use only.

All conductors (L1, L2, L3, neutral, ground) must be connected. Neutral must be bonded to earth ground. Failure

to do so can damage the inverter and void the warranty.
A ProHarvest 208V Inverter AC Cable (ordered separately)
 
PRO208-5k75 CBL-208A-05 (5')
 
PRO208-5k75-AUX CBL-208A-15 (15')

CBL-208A-30 (30')

CBL-208A-50 (50')
Communications Gateway
(ordered separately)

PROGW-A-120
TOOL-KIT-1
(ordered separately)
Includes SD card, Ethernet cable,
120 Vac cable
AC Splice (optional component)

PROSPL-60
Includes AC Connector Tool,
DC Connector Tool
IMPORTANT:
Not intended for use with
life support equipment.
B
C
Date and Revision
January 2017, Revision B