Makita LS004G Instruction Manual page 31

In the case of left bevel cut
(a) (b)
1
1. Inside corner 2. Outside corner
Table (A)
– Molding Bevel angle
position
52/38°
in the
type
figure
(a)
For Left
inside 33.9°
corner
(b)
(c)
For
outside
(d)
corner
Table (B)
– Molding
position in
the figure
(a)
For inside
corner
(b)
(c)
For outside
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° LEFT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the LEFT side of the blade after the cut has been
made.
(c) (d)
2
Miter angle
45° type 52/38° 45° type
type
Left 30° Right Right
31.6° 35.3°
Left Left
31.6° 35.3°
Right Right
31.6° 35.3°
Molding Finished
edge against piece
guide fence
Ceiling Finished
contact edge piece will be
should be on the Left
against guide side of blade.
fence.
Wall contact
edge should
Finished
be against
piece will be
guide fence.
on the Right
Ceiling side of blade.
contact edge
should be
against guide
fence.
In the case of right bevel cut
1. Inside corner 2. Outside corner
Table (A)
– Molding
position
in the
figure
(a)
For
inside
corner
(b)
(c)
For
outside
(d)
corner
Table (B)
– Molding
position in
the figure
For inside
corner
For outside
corner
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° RIGHT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its WALL
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the RIGHT side of the blade after the cut has been
made.
31 ENGLISH
(a) (b) (c) (d)
1 2
Bevel angle Miter angle
52/38° 45° type 52/38°
type type
Right Right Right
33.9° 30° 31.6°
Left
31.6°
Right
31.6°
Molding
edge against
guide fence
(a)
Wall contact Finished
edge should piece will be
be against on the Right
guide fence. side of blade.
(b)
Ceiling
contact edge
(c)
Finished
should be
piece will be
against guide
on the Left
fence.
side of blade.
(d)
Wall contact
edge should
be against
guide fence.
45° type
Right
35.3°
Left
35.3°
Right
35.3°
Finished
piece