Table of Contents
Advertisement
Assembly
Assembly
If necessary, spread out a blanket or similar material to prevent the
TAIKO-1 or floor from being scratched during assembly.
1. Attach the rods to the pad
1
1-1.
Place a pad (
2
) so that the surface with holes in it is facing upward.
1-2.
One at a time, insert the rods (
pad.
1-3.
Use the drum key
8
to tighten the bolts of the rods (
until they no longer turn.
The appropriate tightness is approximately when the bolt head is no
longer visible.
Projection of
the pad
1-4.
Place the other pad (
2
upward.
1-5.
Turn over the pad to which the rods are attached, position the pads so
that the projections of the two pads are aligned, and then consecutively
insert the rods into the holes of the other pad one by one.
1-6.
While making sure that the rods are inserted in the holes of the pad, use
the drum key
8
to tighten the bolts of the rods (
4
1
r
2
1
eight locations) into the holes of the
1
eight locations)
2
) so that the surface with holes in it is facing
1
eight locations) until
they no longer turn.
2. Attaching the sound module
* When attaching the sound module, take care that you are not
injured by an rubber ring.
2-1.
Attach an rubber ring (
4
module (
3
) (four locations).
Gently pull the rubber ring to fit it into the groove.
Rubber ring
1. Fit into this groove
2. Pull gently
2-2.
Loop the rubber ring over the hooks of the rods that are located opposite
the projections of the pads (four locations).
Hook
Projection of the pad
Sound module
3. Attaching the trigger cables
3-1.
Connect the trigger cables (0.2 m) (
pads.
3-2.
Connect the other end of each cable to the TRIG IN 1/2 jacks of the sound
module.
) to each of the four corners of the sound
4
Rubber ring
Hook
5
) to the TRIG OUT jacks of the two
Advertisement
Table of Contents
