Casio XJ-S43W User Manual page 26

Troubleshooting
Problem
No sound comes out
of the projector after
I connect it to
another device.
The color of the
projected image is
strange.
Text in the projected
image is broken up.
The message "Input
the password."
appears and further
operation is not
possible.
Cause and Recommended Action
The projector's volume level setting may be too low
or muted.
➔ Press the remote controller [VOLUME] key and
use [ ] and [ ] to adjust the volume level.
The volume level setting of the device connected to
the computer may be too low or the other device is
not outputting audio.
➔ Adjust the volume level of the connected
device.
The audio output of the connected device may not
be connected correctly to the projector's AV terminal.
➔ Refer to one of the following (depending on
the type of connected device) to check the
connection.
"Connecting a Computer to the Projector"
"Connecting to a Standard Video Device"
"Connecting to a Component Video Output
Device"
When a video device's or computer's HDMI output
is connected to the HDMI port of the projector,
"Line" may be selected for the "Option Settings 2
HDMI Audio Out" setting on the setup menu.
➔ Change the "HDMI Audio Out" setting on the
setup menu to "Speaker".
The input signal may not match projector settings. Try
doing the following.
➔ Use the [BRIGHT] key to adjust image
brightness.
➔ Use the [COLOR MODE] key to change the color
mode.
➔ On the setup menu, use the "Image Adjustment 1
Color Balance" setting to adjust the color
balance.
The image may be out of focus.
➔ On the remote controller, use the [FOCUS
and [FOCUS ] keys to adjust image focus.
If text is broken up even though the image is in
focus and the input source is a computer, the
projector's frequency and/or phase setting may not
be compatible with the input signal.
➔ Press the [AUTO] key to execute an automatic
adjustment operation. If this does not correct
the problem, use the setup menu to adjust the
"Image Adjustment 2
"Image Adjustment 2
manually.
If the input source is a video camera or document
camera, check to make sure there is no problem
with the input source.
The "Option Settings 1
on the setup menu is turned on, so the projector is
password protected.
➔ Input the correct password, and then press the
[ENTER] key.
Frequency" and
Phase" settings
Power On Password" setting
E-26
See
User's Guide
(UsersGuide_
English.pdf)
Device user
documentation
page E-15
page E-15
User's Guide
(UsersGuide_
English.pdf)
User's Guide
(UsersGuide_
English.pdf)
User's Guide
(UsersGuide_
English.pdf)
page E-19
]
page E-19
User's Guide
(UsersGuide_
English.pdf)
Device user
documentation
User's Guide
(UsersGuide_
English.pdf)