Abbott FreeStyle Libre2 Quick Start Manual

FLASH GLUCOSE MONITORING SYSTEM
Quick Start Guide
●
1
Assemble and Apply Sensor to your body
STEP 1
Select site on back of upper arm.
Avoid scars, moles, stretch
Note:
marks, lumps and insulin injection
sites. To prevent skin irritation, rotate
sites between applications. Consider
your comfort and activities.
STEP 4
Line up dark mark on Sensor
Applicator with dark mark on
Sensor Pack. On a hard surface,
press down firmly on Sensor
Applicator until it comes to a stop.
STEP 7
Place Sensor Applicator over site
and push down firmly to apply
Sensor.
Do not push down on
CAUTION:
Sensor Applicator until placed
over prepared site to prevent
unintended results or injury.
Setup Overview
Refer to your User's Manual for full System instructions and information.
Reader
USB Port
Sensor
Pack
Codes on labels
must match
STEP 2
Wash site using a plain soap, dry,
and then clean with an alcohol wipe.
Allow site to air dry before
proceeding.
STEP 5
Lift Sensor Applicator out of
Sensor Pack.
STEP 8
Sensor
Gently pull Sensor Applicator
away from your body.
●
1
Touchscreen
Home Button
●
2
Sensor
Applicator
●
3
CODE XXX
Peel lid completely off Sensor Pack.
Unscrew cap from Sensor Applicator.
CAUTION:
match on Sensor Pack and
Sensor Applicator.
Assemble and Apply Sensor
to your body
Start new Sensor with Reader
Wait 60 minutes
for start-up
Check your glucose whenever you
want for up to 14 days
STEP 3
Cap
Lid
Sensor codes must
CODE
STEP 6
Sensor Applicator is ready to
apply Sensor.
Sensor Applicator
CAUTION:
now contains a needle. Do not
touch inside Sensor Applicator
or put it back into Sensor Pack.
STEP 9
Make sure Sensor is secure.
Discard the used Sensor Pack
and Sensor Applicator. See
Disposal section in the User's
Manual.
XXX