Beem Baby Vital-Center User Manual page 23

EN
CAUTION
► Check the consistency of the baby
food. Make sure that no lumps are in
the food.
► Descale the appliance regularly to
prevent damage to the appliance.
► Do not use sharp objects or abra-
sive cleaning agents to clean the
surfaces.
Requirements for the place of use
For safe and trouble-free operation of the
appliance, the installation location must
satisfy the following requirements:
■ Place the appliance on a dry, flat, wa-
terproof and heat-resistant surface.
■ Do not put the appliance in a hot, wet
or very humid environment.
■ Ensure that there is sufficient space
around the appliance to avoid damage
to cupboards or other objects as the
appliance generates hot steam during
operation.
■ The surface finishes on furniture may
contain substances that can be detri-
mental to the silicon feet of the appli-
ance. If necessary, place a mat under
the feet of the appliance.
■ Select a location that does not allow
children to reach the hot surfaces of
the appliance.
■ The mains socket must be easily ac-
cessible and allow fast disconnection
in the event of an emergency.
BEEM - Elements of Lifestyle
Baby Vital-Center
Electrical connection
For safe and trouble-free operation of the
appliance, the following instructions must
be observed for the electrical connection:
■ Before connecting the appliance,
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. The
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
■ The mains socket must be protected
by at least a 10 A automatic circuit
breaker.
■ Ensure that the mains cable is undam-
aged and is not laid over hot surfaces
or sharp edges.
■ The connecting cable must not be
strained or bent.
■ Always unwind the mains cable com-
pletely before connecting the appliance
to the mains socket.
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
21