Table of Contents
Advertisement
Horizontal steam ironing
1. Remove the hanger fixer.
2. Release buckle 1 of the telescopic pole sockets at the
lower end on the back of the ironing board, lay the ironing
board flat, lock buckle 1 back, and then press the
telescopic button to adjust the ironing board
to the desired height.
Buckle 1
Buckle 2
Note: When adjusting the ironing board,
be sure to lock buckle 2.
3. Wait until the "
" indicator stays
on after flashing, press the level
switching button to select the
desired steam level and start
the ironing.
Refer to "Fabrics and ironing
recommendations" on page 14 for
steam level selection.
16
Notes:
a.Be careful not to damage the garment by the hot soleplate
during ironing.
b.For horizontal ironing, the maximum load
capacity of the ironing board is 3 kg.
c.Set the ironing board upright after each use.
d.The anti-scald rubber pad in the iron holder
may fall off during use, which is not a
malfunction. Please reinstall it in the correct
direction.
Anti-scald rubber pad
Self-cleaning
When the level is set to "
" (self-cleaning), automatic
cleaning is performed.
It is recommended to perform automatic cleaning once after
each use.
During automatic cleaning, hot water and scale may flow out
of the soleplate. Please perform the operation above the sink,
and be careful to avoid scalds or damages caused by dripping
of hot water.
1. Refer to "Filling the water tank" on page 12
to add water.
2.
Insert the power plug into the
household outlet.
3. Press the power button. The power
indicator lights up, and the "
"
indicator also starts flashing.
4. Wait until the "
" indicator stays
on after flashing, and then press and
hold the level switching button for about
3 seconds until the function level
switches to the "
" level.
5. During this process, a large amount
of steam keeps coming out and
automatic cleaning starts.
6. Wait for about 1 minute until the steam
becomes increasingly weak and
eventually ceases to function and the
steam level automatically switches to
"
". Then, put the iron head back
on the iron holder.
• During the self-cleaning process, if you
press and hold the level switching
button again for about 3 seconds or put
the iron head back to the iron holder,
the automatic cleaning function stops,
and the "
" indicator starts flashing.
Wait until the "
" indicator stays on
after flashing before you can use it again.
7. After cleaning, refer to "After use" on page 18.
Auto steam off
If you place the iron head on the iron holder during use, the
auto steam off function will be activated to temporarily turn
the steam off. When you pick up the iron head and resume
the use, the steam will automatically turn on and return to the
state before the pause.
Auto power off when tilting
After the auto power off when tilting function
is triggered when the product is tilt, the power
is turned off automatically, the power indicator
goes off and the function in service is turned off.
When the power base is returned to a stable
surface, the power indicator lights up and the
"
" indicator starts flashing. Wait until
the "
" indicator stays on after flashing
before you can use it again.
17
Advertisement
Table of Contents
