Advertisement
Installing the SKYSCREEN
Before installation
•
Measure the SKYSCREEN and make sure it is the correct size.
•
Make sure the unit is fitted to a flat surface to avoid forcing the unit out of shape when fixing.
•
If SKYSCREEN is large; ensure a minimum of two people undertake the installation.
•
Ensure that the SKYSCREEN is the correct way up and in the desired orientation.
•
Make sure that the SKYSCREEN is not twisted; distortion will damage the blind and affect operation.
1
2
2
3
2
3
4
4
4
x 4
5
6
Check operation of SKYSCREEN.
1
1
x 4
Turn over and remove protective covers from adhesive
pads in each corner.
Ensuring mounting surfaces are free form dust or grease,
use the adhesive pads to hold the SKYCREEN in position
and drill pilot holes. Ensure that the thickness of the boat
structure at the proposed mounting position is deep enough
to prevent the fixing screws from breaking through. Oceanair
recommend No6 x 16mm [5/8"] PANHEAD Screws (not
provided). However if necessary, use shorter fixing screws and
use masking tape on the drill bit as a depth guide to avoid
drilling too deep.
Insert and tighten screws in each corner using
screwdriver, do not use electric screwdriver.
Note:
If the screen is to be fitted on to a soft headlining, we
recommend the use of M4 plastic washers (not supplied) to
shim between the screen and headlining. This will help to
avoid distortion of the frame and over compressing the
headlining material.
Page 4 of 8
2
Open screw covers as shown.
1
Close screw covers.
Advertisement
