Advertisement
5.
Secure end frames and lower support with
(2) external corner braces and (2) internal
corner braces, using (3) M8-1.25 x 55 button
head cap screws, (6) 8mm flat washers, and
(3) M8-1.25 lock nuts for each corner (see
Figure 6). DO NOT fully tighten fasteners at
this time.
External
Corner
Brace
Lower
Support
End Frame
Figure 6. End frame and lower support secured
together with corner braces.
6.
Thread (4) rubber feet into bottoms of end
frames (see Figure 7).
Rubber
Foot
Figure 7. Adjustable feet attached.
Model T31830/T31831 (Mfd. Since 01/20)
x 3
Internal
Corner
Brace
End Frame
7.
Turn workbench upright and make sure it is
centered over end frames and supports (NOT
leaning to one side or the other), then fully
tighten all fasteners.
8.
Adjust feet as necessary to level table. Verify
workbench sits firmly on ground, and does
not wobble.
Note: Lay a level across the workbench
top from side-to-side and end-to-end when
adjusting feet.
9.
Insert steel bars through end frames as
desired (see Figure 8).
Note:
Each
end
holes, which allows for numerous shelving
and racking configurations.
End Support
Frame
Steel
Bars
Figure 8. Steel bars inserted.
frame
has
several
-3-
Advertisement
