Sumitomo ETK1423090 Instruction Manual

SUMITOMO ELECTRIC
INDUSTRIES,LTD.
ETK1423090

For your safety operation

This product has been designed and manufactured to assure
personal safety. Improper operation can result in bodily injury
and serious damage to this product. Please read and observe
all warnings instructions given in this operation manual.
★Wear safety glasses before handling optical fiber to protect
the eyes. Because the small pieces of glass fibers are very
sharp and might get into the eyes, stab a finger and injured
them.
★Never look into the end of a connector or an optical fiber
which may have a laser coupled to it. Laser light might
damage your eyes. Please note that laser light is not visible.
★In the case of the work at the high place, please be careful not
to drop an assembling tool. （Please use a wrist strap etc.）

Product Composition

Connector (1pc)
Insertion guide jig
(Attached 2pc per
100 connectors)
Cable preparation procedure in advance （1-fiber cable and 2-fiber cable）
①Split the cable tip
with nipper
Examples
Conventional
Outdoor/Indoor
Drop Cable
Notch
Low-Friction
Outdoor/Indoor
Drop Cable
［Contact］
Copyright © 2014 Sumitomo Electric Industries, LTD.
Field Assembly Connector "e-SC"
Instruction Manual
Applicable rectangular cable dimension
type 1
1.6 +/-0.1 x 2.0+/-0.1mm
Cable holder (1pc)
E-SC Cut spacer
(Attached 2pcs per
100 connectors)
②Split cable jacket
by hand
Notch
Sumitomo Electric Industries, Ltd. Light wave Network Products Division,
TEL +81-45-853-7223
2.0 +/-0.2 x 3.1+/-0.2mm
①Improper assembly will result in a loss of performance.
②The product is sensitive to dust. Do not take out
the connector from the package until it is to be used.
③The product performance depends on cleaved fiber
endface statement. Fiber cleaver shall be maintained
properly before using cleaver.
④Please insert the fiber into the connector slowly, otherwise
fiber might be damaged and cause assembly error.
Please also keep safety against scattering broken fiber.
⑤Do not remove the dust cap until the connector has been
completely assembled in order not to cause an high
insertion loss.
⑥In case of re-assembling a connector, please be careful to
do it to prevent from dust, contamination and so on. Re-
assembled connector's performance is under customer's
responsibility.
Examples of Assembling tool
Following tools shall be required adding above parts,
①Fiber Cleaver
FC-7
*for flat cleaving
③Cut cable jacket
！
※Attention:
Take care not to damage to φ0.25mm fiber to
keep good reliability.
FAX +81-45-851-1286
type 2

Precautions

!
②Jacket remover
④Cut needless fiber
(In case of 2-fiber cable)
！
Keep equal cutting edge on
both cable jacket
*Attached Insertion guide jig
can be used as a scale.
45mm
for φ0.25mm
fiber position
JR-M03
45mm