Tripp Lite B110-SP-CAT-OD2 Quick Start Manual page 5

P68-rated gigabit poe outdoor in-line

Hide thumbs Also See for B110-SP-CAT-OD2:

Table of Contents

Installation

Protecting Edge-Of-Network Equipment

This installation protects your edge equipment from surge,

lightning or ESD damage. To protect both the source and edge

equipment, refer to section Protecting Edge-Of-Network

Source and Equipment in this guide.

Note: Use standard size Cat5e, Cat6 or Cat6a cables that feature a

wire gauge of 23/24 AWG. Slim category cables are not supported.

1. Remove both the cap

cable glands (refer to section Cable Gland Assembly).

2. Slide the cap and remaining portion of the cable gland onto

both the included grounding wire and bare-wire category

cable coming from your source (ex: PoE switch) as shown:

Note: Use standard Cat5e, Cat6 or Cat6a cables with a wire gauge

of 23/24 AWG. Slim category cables are not supported.

and end nut

from one of the

Table of Contents