Page 1
Страница 1 / 4 Rev.20131002 Outlander III ADDENDUM - SUGGESTED WIRING CONFIGURATION ДОПОЛНЕНИЕ - ПРЕДЛАГАЕМАЯ СХЕМА ПОДКЛЮЧЕНИЯ NO KEY TAKE OVER ПЕРЕХВАТ КЛЮЧА (МЯГКАЯ ПОСАДКА) ОТСУТСТВУЕТ Доступные функции PUSH START ГОДЫ VEHICLE | АВТОМОБИЛИ MITSUBISHI Outlander III Push to Start 2013 At Steering Column, Right side На...
Page 2
This Guide may be changed without notice. Visit www.ifar.ca for latest version. Страница 2 / 5 Page 3 / 4 Это руководство может изменяться без предупреждения. Посетите www.ifar.ca для получения последней версии. KIA RIO - PUSH-TO-START Outlander III (PTS) WIRING CONNECTION | СХЕМА ПОДКЛЮЧЕНИЯ 3 / 5 Page (-) Hood status | Капот...
Page 3
Страница 3 / 5 ДАННОЕ РУКОВОДСТВО МОЖЕТ ИЗМЕНЕНЯТЬСЯ БЕЗ ПРЕДУПРЕЖДЕНИЯ This manual may change without notice. www.ifar.ca for latest version. KIA RIO - PUSH-TO-START Outlander III (PTS) STAND ALONE INSTALLATION | ОТДЕЛЬНАЯ УСТАНОВКА Configure the EVO-ALL as a Stand Alone Remote Starter: Connect the module to the FlashLink Updater 2 (sold separately) and use the FlashLink Updater software to enable option #15 in options menu.
Page 4
3 / 4 Page This manual may change without notice. www.ifar.ca for latest version. PROGRAMMING PROCEDURE | ПРОЦЕДУРА ПРОГРАММИРОВАНИЯ If the LED is not solid BLUE disconnect the 4 Pin connector (Data- Link) and go back to beginning of step 1 Если светодиод не горит СИНИМ, отключите Press and hold Insert the 4 Pin The LED will Release the Insert the required...
Page 5
Only a computer safe logic probe or digital multimeter should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in every case is the sole responsibility of the installer performing the work and FORTIN ELECTRONIC SYSTEMS assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly or any other way.