Advertisement
Condition
The Jump Start button
flashes green continuously
The powerstation go
rugged AC displays a blue
or red "TEMP" indicator
You can not successfully
jump start your vehicle. The
powerstation go rugged AC
displays a vehicle battery
voltage greater than 12.0V
The Jump Start and On/Off
button flashes red and white
Charging a laptop (via the AC output port)
1. Connect the AC power plug from your laptop (or other electronic device which is rated at 65 watts or less)
into the AC output port of the powerstation go rugged AC.
NOTE: Any electronic device can be powered by the AC output port as long as it is rated at 65 watts
or less. BE SURE TO CHECK THAT YOUR LAPTOP OR OTHER ELECTRONIC DEVICE IS RATED AT 65 WATTS
OR LESS.
Figure 5
Potential Cause
The powerstation go
rugged AC is waiting to
be connected to a battery
or a SAFETY CHECK FAIL
has been triggered.
The powerstation go rugged
AC has detected a low or
high temperature condition.
The powerstation go rugged
AC detects that it is connected
to a vehicle battery with a
normal starting voltage. This
could indicate that another
vehicle component is faulty.
This could occur when
attempting to jump start a
vehicle while other electrical
components (i.e. headlights,
heater, radio, etc.) are on.
The vehicle battery
may be faulty.
Solution
Check the jumper cables and
ensure they are properly connected
to the battery. Check and ensure
the vehicle battery voltage is
greater than 2.0V. If the SAFETY
CHECK FAIL indicator is triggered
during the jump start process, it
is recommended that you consult
with a certified mechanic.
Disconnect the powerstation
go rugged AC and allow unit
to acclimate to temperature
operating range (14°F to
122°F) (-10°C to 50°C).
It is recommended that you
consult with a certified mechanic.
Turn off your headlights and
any other components that may
drain your car battery and try
the jump start process again.
It is recommended that you
consult with a certified mechanic.
Advertisement
