Table of Contents
Advertisement
W h i t m y e r H e a d S u p p o r t s
1. Unsnap horizontal pivot cover (Fig. 2, B). Angle T-handle or ball driver beneath tab
and push up and outward. Refer to Fig. 1. Index pin on anti-rotational collar (Fig. 1, C)
fits in to slot in top of detach receptacle (Fig. 1, D) to prevent rotation.
Adjustments
1. Vertical - Loosen the lever knob (Fig. 1, F) and adjust to the proper height and then
lower the stop collar (Fig. 1, C) be sure to align the index pin in the slot on the detach
mount. (Fig. 1, G) Vertical rod may be rotated for additional angle adjustment of pad/
base plate assembly.
2. Horizontal / Angle – Loosen pivot bolts (Fig. 1, A) for depth (Fig.4) and angle (Fig.3)
adjustments. It is not necessary to fully tighten all screws until final position is
achieved.
3. Tighten all collar screws evenly to reach full locking strength. See page 15.
4. Snap horizontal pivot cover (Fig. 2, B) in place.
MKT6100 Rev. C
A
B
C
E
G
D
F
Fig. 1
A
A
Fig. 3
14
Pro Mounting System
Fig. 2
E
Fig. 4
Advertisement
Table of Contents
