Brother Computerized Embroidery Machine Operation Manual page 32

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Open the top cover.
d
e Remove the spool cap that is inserted onto the
spool pin.
a Spool pin
b Spool cap
Place the spool of thread onto the spool pin.
f
Slide the spool onto the pin so that the spool is
horizontal and the thread unwinds to the front
at the bottom.
CAUTION
● If the spool or the spool cap is not
positioned correctly, the thread may
become tangled around the spool pin or
the needle may break.
1
2
Slide the spool cap onto the spool pin.
g
Slide the spool cap as far as possible to the
right, as shown, with the rounded side on the
left.
h While holding the thread lightly with your
right hand, pull the thread with your left hand,
and then pass the thread behind the thread
guide cover and to the front.
a Thread guide cover
i Pass the thread under the thread guide plate,
and then pull it up.
1
a Thread guide plate
1
Upper Threading 31
1