Adding More Ingredients; After You Have Finished Using Your Appliance; Cleaning And Care - Silvercrest SKMP 1300 D4 Operating Instructions Manual

–
Twist the lid catch
(towards ).
The lid catch
one side and into the handle of the blender
on the other (fig. 3).
Fig. 3
–
Slide the measuring cup
as far as it will go.
6) Turn the rotary switch
NOTE
► The ideal speed depends on the consistency
of the items being mixed. The more liquid the
contents are, the faster you can blend them.
► For short, powerful impulses, set the rotary
switch to level 1 or higher and press the
PULSE button simultaneously. The PULSE
button does not lock into place so as not
to overload the motor. Press the PULSE button
only for short periods.

Adding more ingredients

1) Turn the appliance off using the rotary switch
2) Remove the blender lid
–
Twist the lid catch
(towards ) and pull it upwards to take
it off the appliance.
–
Pull the blender lid
■ 26 │ GB │ IE
clockwise by 90°
will slide over the spout on
into the lid catch
to the desired level.
:
anticlockwise by 90°
off the blender
3) Add the ingredients.
or
4) Take the measuring cup
lid by pulling it upwards. Gradually add
the ingredients through the opening.
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch
2) Turn the blender
that the ▼ arrow on the blender
to the ▲ arrow on the appliance and remove it.
NOTE
► You should clean the blender
after use (see the section "Cleaning and
care"). This makes food residues easier to
remove.

Cleaning and care

DANGER – RISK OF ELECTRIC
SHOCK!
► Before cleaning the appliance, disconnect
the power plug from the mains power socket!
There is a risk of electric shock!
Never immerse the appliance in water or
any other liquid!
ATTENTION! PROPERTY DAMAGE!
► Do not use abrasive or aggressive cleaning
materials. These may damage the surfaces.
.
NOTES
► We recommend cleaning the appliance
directly after use. This makes food residues
easier to remove.
► Processing foods, such as carrots, that contain
strong pigments may lead to staining of the
.
plastic parts. These stains can be removed
using a little cooking oil.
out of the blender
anticlockwise (direction
is pointing
immediately
SKMP 1300 D4
.
) so