Working With The Blender - Silvercrest SKMP 1300 D4 Operating Instructions Manual

Working with the blender

WARNING! RISK OF INJURY!
► Always allow hot fluids to cool down to a
lukewarm temperature (approx. 30–40°C)
before pouring them into the blender
WARNING! RISK OF INJURY FROM
SHARP BLADES/ROTATING DRIVE!
► Never put your hand into the attached
blender !
► Remove the blender
is at a complete standstill.
► Do not operate the blender
blender lid , lid catch
jug .
► In the event of malfunction, switch the appli-
ance off and remove the plug from the wall
socket to prevent the appliance from being
switched back on unintentionally.
ATTENTION! PROPERTY DAMAGE!
► The drive shaft for the attachments
rotates while the blender
use the mixing bowl
same time! This will overload the motor!
► When working with the blender
recommend allowing the appliance to cool
down after 3 minutes of operation.
Proceed as follows to prepare the blender
operation. Use figure C on the rear fold-out page
as a guide.
1) Press the release lever
the swivelling arm
working position.
2) Pull the drive unit lid
fig. C/fold-out page).
NOTE
► Ensure that the rotary switch
to "0" before you place the blender
the blender drive unit
appliance will start immediately as soon as
the blender has locked into place.
SKMP 1300 D4
.
only when the blade
without the
and measuring
is in use. Never
and blender at the
, we
for
upwards and push
downwards into the
off to the right (see
is turned
on
. Otherwise, the
3) Place the blender
so that the lock tabs on the underside of
the blender lock into the recesses on the
blender drive unit
on the blender
symbol ▲ on the appliance. Twist the blender
clockwise (towards
locks into place.
4) Add the ingredients.
5) Attach the blender lid
–
Place the blender lid
that the lip of the blender lid
spout.
–
Attach the lid catch
on the lid catch
in the blender lid
with lock symbols (
the European scale (ml/litre), as in fig. 2.
Fig. 2
on the blender drive unit
. The arrow symbol ▼
must line up with the arrow
) until it noticeably
:
on the blender so
seals the
so that the lock tabs
slide through the gaps
. The wide tab marked
) must point at
GB │ IE │ 25 ■