Canon i900D Series Printing Manual page 45

Message
Photo Paper Tray is lowered.
Turn the dial to use the sheet
feeder.
Error code
Adjusting the Print Head Manually
Note
If the automatic print head adjustment does not work or if you wish to adjust
the print heads manually, follow the procedure below.
1. With the printer on, load a sheet of Letter plain paper in the printer.
2. Press the Menu
3. Use the
4. Use the
If the Same Error Persists
If the same error persists after a countermeasure is taken according to the
above errors, turn off the printer, remove the power cord plug from the outlet,
plug the power cord back in, and then turn on the printer again.
44
• When paper feeding is set to be done from the Photo Paper Tray, paper cannot be fed
from the Sheet Feeder.
Turn the knob on the Photo Paper Tray to change the way to feed paper.
• The size of paper loaded in the Photo Paper Tray may be different from the paper size
selected on your digital camera or the operation panel of the printer.
When printing from the digital camera, change the paper size setting of the digital
camera to the size of paper loaded in the Photo Paper Tray.
When using the digital camera that cannot select the paper size or when printing from
a memory card, change the setting on the operation panel of the printer.
Turn off the printer, remove the power cord plug from the outlet, plug the power cord
back in, and then turn on the printer again.
If the same error persists, contact the Customer Care Center.
Menu button.
Menu Menu
buttons to select Maintenance
button.
buttons to select Manual head align
button.
5. Use the
OK button. OK OK OK
6. The message "Did the pattern print properly?" is
displayed on the LCD.
Use the
OK button. OK OK OK
7. Examine the printed pattern and enter the number of
column "A" with fewest white stripes using the
buttons.
8. Press the OK
9. Use the
10.Repeat Steps (6) through (8) and enter the pattern
numbers up to column "G".
11.After entering the pattern numbers up to column "G",
press the OK
Try This
Maintenance and then press the OK
Maintenance Maintenance
Manual head align and then press the OK Manual head align Manual head align
buttons to select Yes
buttons to select Yes
OK button.
OK OK
button and move the cursor to column "B".
OK button.
OK OK
OK
OK OK
Yes and then press the Yes Yes
Yes and then press the
Yes Yes
OK OK OK