Table of contents 1. Safety regulations 2. Layout and items supplied 3. Proper use 4. Technical data 5. Before starting the equipment 6. Operation 7. Cleaning, maintenance and ordering of spare parts 8. Disposal and recycling 9. Storage 10. Charger indicator - 5 - Anl_TE_CD_18_44_Li_i_Kit_SPK7.indb 5 Anl_TE_CD_18_44_Li_i_Kit_SPK7.indb 5...
Page 6
Danger! - Read the operating instructions to reduce the risk of inquiry Caution! Wear ear-muff s. The impact of noise can cause damage to hearing. Caution! Wear a breathing mask. Dust which is injurious to health can be generated when working on wood and other materials.
Danger! 2.2 Items supplied When using the equipment, a few safety pre- Please check that the article is complete as cautions must be observed to avoid injuries and specifi ed in the scope of delivery. If parts are damage. Please read the complete operating missing, please contact our service center or the instructions and safety regulations with due care.
4. Technical data The stated vibration emission levels and stated noise emission values can also be used to make an initial assessment of exposure. Voltage supply ........18 V d.c. Idling speed: ......0-350/0-1250 rpm Warning: Torque settings: ........18+1+1 The vibration and noise emission levels may vary Forward and reverse rotation ......yes from the level specifi...
5. Before starting the equipment 6.2 Torque setting (Fig. 4 / Item 1) Important! The tool must be at a standstill when you set the torque with the setting ring. Be sure to read the following information before The cordless screwdriver is fi tted with a mechani- you use your cordless screwdriver for the fi...
6.5 On/Off switch (Fig. 5 / Item 4) 6.10 Screwdriving Infi nitely variable speed control is possible with We recommend using self-centering screws (e.g. the On/Off switch. The further you press the Torx screws, recessed head screws) designed for switch, the higher the speed of the battery-powe- reliable working.
8. Disposal and recycling The equipment is supplied in packaging to pre- vent it from being damaged in transit. The raw materials in this packaging can be reused or recycled. The equipment and its accessories are made of various types of material, such as metal and plastic.
10. Charger indicator Indicator status Explanations and actions Red LED Green LED Off Flashing Ready for use The charger is connected to the mains and is ready for use; there is no battery pack in the charger Off Charging The charger is charging the battery pack in quick charge mode. The char- ging times are shown directly on the charger.
Page 13
For EU countries only Never place any electric power tools in your household refuse. To comply with European Directive 2012/19/EU concerning old electric and electronic equipment and its implementation in national laws, old electric power tools have to be separated from other waste and disposed of in an environment-friendly fashion, e.g.
Page 14
Service information We have competent service partners in all countries named on the guarantee certifi cate whose contact details can also be found on the guarantee certifi cate. These partners will help you with all service re- quests such as repairs, spare and wearing part orders or the purchase of consumables. Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also required for use as consumables.
Page 15
EÚ a noriem pre výrobok Lýsir uppfyllingu EU-reglna og annarra staðla vöru a cikkekhez az EU-irányvonal és Normák szerint a következő konformitást jelenti ki Cordless Hammer Drill/Screwdriver / Power X-Charger (Einhell) 2014/29/EU 2006/42/EC Annex IV 2005/32/EC_2009/125/EC Notifi ed Body: (EU)2015/1188 Reg.