Operation - Makita DVC340 Instruction Manual

Installing dust bag
2
1
3
1. Dust outlet
2. Dust bag joint
3. Pins
4. Dust bag
011113
Hold the square section of the dust bag joint and fit the
pins inside the dust bag joint to the notches in the dust
outlet of the cleaner and then insert and turn it clockwise
all the way until it stops.
Fig.5
At this time, make sure that the fastener part on the dust
bag faces upward.
NOTE:
When the dust bag joint and the ring inside the dust
•
bag come off, install as follows.
(1) Align the dust bag joint with the seam of the
dust bag and install it so that its protrusion
faces upward.
Fig.6
(2) Tighten the ring inside the dust bag firmly so
that the pins and the ring are positioned as
shown in the figure.
Fig.7
Installing the shoulder strap
Fig.8
Attach one end hook of the shoulder strap onto the ring in
the front of the cleaner and thrust the other end of the
strap through the band of the dust bag and then attach
the other end hook as shown in the figure.
Adjusting the shoulder strap
Fig.9
To adjust the length of the shoulder strap, pull it out to
your desired length and pull the strap in the direction of
arrow as shown in the figure.
Connecting the hose
CAUTION:
Do not force the hose to bend it and/or stamp it.
•
Forcing and/or stamping the hose may cause
deformation or damage to the hose.
Do not pull the hose to carry the cleaner. Pulling the
•
hose may cause deformation or damage to the hose.
4
B
1
2
1. Dust outlet
2. Power tool
011119
Insert the "A" end of the hose to the suction opening of
the cleaner and turn it clockwise all the way until it locks.
Attach the cuff on the "B" end of the hose and then
connect it to the dust outlet of an power tool.
Replacing the front cuff
Change the front cuff of the hose according to the dust
outlet size of a power tool you use.
Fig.10
To remove the front cuff, hold the hose and turn it
counterclockwise.
To mount the front cuff, turn it clockwise and then screw
it in until it stops.

OPERATION

WARNING:
Do not use the shoulder strap when working in a
•
high place.
When using the cleaner as a stationary cleaner,
•
place it on a flat and stable surface.
Vacuum Cleaner
Fig.11
When using the cleaner as a portable cleaner,
cross-hanging the shoulder strap before the breast is
difficult to drop the cleaner.
8
A