Related Manuals for Isotek Genesis EVO3
Summary of Contents for Isotek Genesis EVO3
- Page 1 EVO3-Genesis-Instructions_OLD-MiniSub-GII-Instruc.qxd 08/03/2012 11:01 Page 1 March 2012 Multi award winning power management systems Genesis Instruction Manual...
-
Page 2: Table Of Contents
EVO3-Genesis-Instructions_OLD-MiniSub-GII-Instruc.qxd 08/03/2012 11:01 Page 2 March 2012 Contents General section A. Introduction The company The principles The execution B. The product Overview B.2-3 Features Safety C. Installation Placement Equipment coupling System integration D. Troubleshooting Fault finding E. Specifications Dimensions & sockets G. -
Page 3: Introduction
A. Introduction The company The company IsoTek was formed in England July 2001 with the vision to create high quality mains power distribution units that moved beyond current conventions. Through careful market analysis and extensive research we were able to launch products that moved power distribution forward to be recognised as an integral part of any audio or home theatre system. -
Page 4: The Product
Overview The IsoTek Genesis completely re-defines the term mains re- generation. IsoTek believe it to be the first true mains generator. The mains sine wave is not corrected (as in other devices) but totally and completely rebuilt, ‘generated’ from new with a THD distortion figure of less than 0.3%. -
Page 5: Features
DACs, Pre-amplifiers etc. Power amplfiers SHOULD NOT BE CONNECTED. The input is a high quality C20 IEC, IsoTek’s Extreme power cable is included to power the unit. At the rear is an RCBO this needs to be engaged prior to turning on the unit at the front. -
Page 6: Safety
Should either of these events happen immediately switch off the unit at the wall socket, wait for at least one minute, unplug all other cables and return it to your authorised IsoTek dealer for a full service. 20Kg 20Kg... -
Page 7: Installation
EVO3-Genesis-Instructions_OLD-MiniSub-GII-Instruc.qxd 08/03/2012 11:01 Page 7 March 2012 C. Installation Cable connection & power on Equipment Once Genesis is positioned, connect the unit to a mains wall socket. coupling Plug the supplied Extreme power cable into the right C20 IEC and then into the wall socket. -
Page 8: Troubleshooting
Fuse in UK three pin plug We would strongly recommend a simple check of mains polarity. Your local IsoTek authorised dealer will be able to supply a product through us to help you establish this. Mains polarity is of particular importance in markets where European Shuko plugs are used. -
Page 9: Specifications
EVO3-Genesis-Instructions_OLD-MiniSub-GII-Instruc.qxd 08/03/2012 11:01 Page 9 March 2012 E. Specifications Front & rear elevation Dimensions The following information relates only to the IsoTek Genesis. & sockets Number of outlets: Type of outlets: UK, US, EU, ZA, AU, CH unswitched Mains inlet:... -
Page 10: Warranty
G. Warranty Please complete & send As part of our on-going commitment to the highest standards of customer service, IsoTek offers you the opportunity to extend the standard 2 year product warranty to 3 years, free of charge. Simply visit: www.isoteksystems.com/register...